Smith & Nephew
US Professional

Advanced Search
  • Home
  • Products
  • Training and Education
  • Resources
  • News & Careers
  • Home
  • Products
  • Featured Products
  • TRIGEN
  • Design Rationale
  • Fatigue Testing
  • Home >
  • Products >
  • Featured Products >
  • TRIGEN >
  • Design Rationale >
  • Fatigue Testing
  • FAN Nail Strength
  • Fatigue Testing
  • Hole Chamfer Effect
  • Knee Nail Strength
  • Occluded Canal Area
  • Patented Hybrid Bow
  • Screw Bending Test 4.5mm
  • Screw BendingTest 5.0mm
  • Screw Pullout Test
  • Screw Seating Surface
  • Screw Temp/Torque Testing
  • TRIGEN FEA Analysis
  • Print
  • e-mail

Email this page

close
  1. Mandatory fields are marked with an asterisk [*].

    Tell us who you want to send your mail to Fill in your email details

    Note: Smith & Nephew does not collect or make use of the email addresses or names provided here. They are only used to show the recipient who has sent the message.

    Change your message if you want Change the message if you want to

    1. <recipient name> <address>
    2. <sender name> <address>
    3. <sender name> is sending you a link

    4. <sender name>

    Visitor verfication

Email sent successfully
Error: Check all fields are valid. Exclude special characters from Comments field
Smith
Nephew

TRIGEN™

Intramedullary Nails

Fatigue Testing

  • Instruments
  • Implants
  • Cases
  • FAQ
  • Design Rationale
  • Click here to contact us

Trigen_DesignRationale_FatigueTesting1
 
Trigen_DesignRationale_FatigueTesting2
  • Test was set up to simulate worst case conditions.
 
  • Reproducible set up made from materials with mechanical properties of bone.
 
  • Tibia mode was tested since it was the worst case conditions.
 

Load conditions derived using the stance phase of the gait cycle.

  • ◊ Trademark of Smith & Nephew | This information intended for United States customers only
  • Accessibility
  • Copyright & Disclaimer