Email this page

Mandatory fields are marked with an asterisk [*].

Fill in your email details
1. * Your name:
2. * Your email address:
3. * Recipient name:
4. * Recipient email address:
Note: Smith & Nephew does not collect or make use of the email addresses or names provided here. They are only used to show the recipient who has sent the message.
Change the message if you want to
1. To: <recipient name> <address>
2. <sender name> <address>
3. Subject <sender name> is sending you a link
4. Hi,
  I saw this on the Smith & Nephew site and thought you might be interested.
5. <sender name>
Visitor verification
1. *Type the code shown

TRIGENSNTM Intramedullary Nails

TRIGEN Entry Reamer

Design Rationale

Designed to offer a convenient method for preparing the bone to accommodate the diameter of the driving end of the implant. Procedures using the Femoral Antegrade Nails (FAN) use the entire Assembly. Knee Nails use only the 12.5 mm Entry Reamer.




12.5 mm Entry Reamer (7163-1116) 14 mm Channel Reamer (7163-1118) Entry Reamer Connector (7163-1120)

Assembly

The assembly is designed so that the entry reamer connector conveniently screws onto the 14 mm channel reamer. The 12.5 mm entry reamer is inserted into the 14 mm channel reamer and easily connects to a power drill. The assembly is then inserted through the entry tool to ream the intramedullary canal. The moving parts of the assembly are in gold to make it easier to identify during disassembly.

Features	Benefits
Entry Reamer Assembly	Designed to provide options when reaming for the diameter of the driving end of the implant. The design of the assembly makes it more economical to replace parts as they wear out.
12.5 mm Entry Reamer	Conveniently connects to a power drill to ream the intramedullary canal in preparation for the implant. The shaft is flexible. It is used with the 14 mm channel reamer for FAN Nail procedures and by itself with Knee Implants.
14 mm Channel Reamer	Used with FAN Nails to prepare the bone to accommodate the proximal diameter of the implant. The assembly is inserted through the entry tool. The channel reamer is left in place after proximal reaming is complete to extend the working channel of the entry tool.